FANWALL TECHNOLOGY ® One of the most innovative and exciting new trends in air handling in the past few decades is to use a multiple fan array to move air versus traditional single or dual fans. HUNTAIR, Inc. was first to invent an "integrated" fan array solution with its FANWALL system and continues to be the industry leader in ongoing research and development to further refine its capabilities. ®.

Unlike other fan arrays available today, a FANWALL system is more than off-the-shelf fans and motors arranged in an array. It incorporates FANWALL TECHNOLOGY-innovated and manufactured specifically for fan array systems-to create an integrated system of state-of-the-art fans, motors, cabinetry, controls, and accessories.

These components have been successfully blended to match new construction and retrofit application requirements, while providing the benefits of:

• Redundancy
• Quiet and vibration-free operation
• Optimized energy efficiency from design minimum to maximum flow
• Low cost maintenance and service

Since 2003, more than 40,000 FANWALL cubes have been installed and are successfully moving over 250 million cfm throughout the world.

For more information, visit www.fanwalltechnology.com.

View the timed installation of one Huntair retrofit project.

Huntair Retrofit Project

HUNTAIR air handling equipment is custom in concept, yet competitively priced, giving designers the ultimate in flexibility when solving their HVAC design problems. Most configurations are available with pre-piped and pre-wired control systems which have been factory tested and certified prior to shipment. Packaged systems give single source responsibility, simplifying designing, specifying, purchasing, installing, and servicing.
Sizes are available up to 200,000 CFM with heating and/or cooling capacities appropriate for any application. Units may be configured with a variety of outside air, return air, and supply air damper options. Multiple options of fan type, style and discharge arrangement are available.

Features:

• All welded structural steel base with tubular steel intermediate floor supports
• 12 , 14, 16, or 18 Ga. Exterior walls
• Single or double wall construction
• Hinged heavy-duty access doors
• Centrifugal, plenum or axial fan options
• Internal spring isolation
• Hot water or steam coils
• Direct fired gas heat / Indirect fired gas heat / Electric heat
• Chilled water coils, DX cooling coils
• Direct evaporative cooling / indirect/direct evaporative cooling
• Factory run tested and certified prior to shipment
• Pollution control equipment, ESP electrostatic precipitators
• Sizes up to 200,000 CFM
• Fan / Motor / Drive assemblies are dynamically balanced prior to shipment

For more information, visit http://www.HUNTAIR.com.